BOB AA000001 Manuel d'utilisateur

TraySharp Screw 2xPivot Screw 2xPivot Plug 2xPivot Nut 2xRestraintBelt FRestraintBelt MArmAccessory BarAccessory BarShort Screw (installed)Long Screw(

Position arm between canopy and frame.Align arm hole over fabric grommet and rivet nut. Position arm between canopy and frame.Align arm hole over fabr

• The BOB Infant Car Seat Adapter is designed for use with single seat BOB Strollers and compatible Infant Car Seats. This product is not a universal

LIMITED WARRANTYBOB Trailers Inc. takes pride in its workmanship and strives to manufacture the best products possible. Therefore, we warranty the ICS

PivotPivotBracketBracketRotate arms into an upright position.POSITION ARMSATTACH MAIN BARINSTALL PIVOT NUTTIGHTEN PIVOT NUTUse a Phillips screwdriver

Extend canopy to expose lower fabric screw.Remove screw with Phillips screwdriver, exposing fabric grommet and rivet nut.Repeat on other side.INSERT S

POSITION CANOPY Position canopy against handle bar.UNBUCKLE RESTRAINT BELTUnbuckle restraint belt. Place ends outside seat.PREPARE STROLLER FOR INFANT

TO REMOVE Britax® Go To Pull on red ring to tighten.TIGHTEN RESTRAINT BELTBe sure restraint belt tension is not constricting child as it may cause se

FASTEN RESTRAINT BELTENGAGE CAR SEATPeg Pérego® TO REMOVE Peg Pérego® Go To Be sure restraint belt tension is not constricting child as it may cau

ENGAGE CAR SEATFasten restraint belt over top of infant car seat as shown.FASTEN RESTRAINT BELTRAISE SEAT BACKREMOVE ACCESSORY BARUsing a Phillips scr

Pull on red ring to tighten.TIGHTEN RESTRAINT BELTTO REMOVE Graco® Go To Be sure restraint belt tension is not constricting child as it may cause seri

REMOVE ACCESSORY BARTRAY INSTALLATIONREMOVE SCREWSUsing a Phillips screwdriver, remove long screws from tray.SECURE TRAYInsert long screw through each